Instructions / Assembly

Fig.1

Set#: A-021-170A

-Mounting plate

-Green screw

-Mounting screw(2)

INSTALLATION INSTRUCTIONS FOR P5540-66A-L

For LED Pendant

READ AND SAVE THESE INST

TIONS

WA R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R

A V E R T I S S E M E N T ! C O U P E R L E C O U R A N T A U N I V E A U D E S F U S I B L E S O U D O

I S J O N C T E U

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off power at the fuse box or circuit breaker box and

remove the old fixture including the mounting hardware.

2. Carefully unpack your new fixture and lay out all the parts in

a clear area. Take care not to misplace any small parts

necessary for installation.

3. Attach mounting plate (A) to junction box (not included) using

mounting screws (C) (Size: 8-32*1/2’’L). The side of mounting

plate (A) marked “GND” must face out.

4. Adjust strainers (F) to your desired length.

CONNECTING THE WIRES (Fig.2)

5. Connect the electrical wires as shown in Fig.2, making sure

that all wire connectors are secured. If your junction box has

a ground wire (green or bare copper), connect fixture's

ground wire to it. Otherwise, connect the fixture's ground wire

directly to mounting plate (A) using the green screw (B)

provided.

COMPLETING THE INSTALLATION

6. Align canopy (E) onto mounting plate (A) and secure with

screws (D).

7. Adjust the angle of LED disk (G) to the appropriate position

you desire (CAUTION: Please adjust in the direction of the

arrow) (the maximum adjustment angle of LED disk (G) is 180

degrees, please be careful not to use too much force)

Your installation is now complete. Return power to the junction

box and test the fixture.

CAUTION /ATTENTION: When handling fixture, do not apply

pressure to LEDs. Hold fixture by the base only.

IMPORTANT: Fixture should be installed by a qualified electrician.

to ensure proper wiring and installation.

Dimmable with ELV and/or LED compatible wall dimmer

switches.

Fig.2