Installation Guide

CAUTION/ATTENTION: When handling the
fixture, do not apply pressure to the LEDs. Hold
the fixture by the base only.
Replacing LED module (Fig. 3)
The LED module can be replaced by a qualified
electrician without cutting of wire and without
damage to any decorative element to which the
fixture is attached. See installation steps for
more details (Fig 3.)
a. Shut off the power.
b. Remove screws (E) and plastic washers (Q),
than remove fixture body from mounting plate (B),
disconnect the wire connector, and place fixture
body on a clean surface.
c. Loosen screws (H) and remove glass shade (J).
d. Loosen screws (F) and remove glass panel (K).
e. Loosen screws (I) and remove bracket (M).
f. Press the button of the printed “L” quick
connector on LED module (O) with screwdriver
(not included) to disconnected the black wire,
and then disconnect the white wire from the
printed “N” quick connector on LED module (O).
g. Remove screws (N). Carefully remove the LED
module (O).
h. Reverse steps b-g for installing the new LED
module.
Your installation is now complete. Return power and
test the fixture.
Page:2/2
Fig. 3
Fig. 4
BACK PLATE
CAULKING
LA-3253E
Note: Illustration (Fig.1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased
.
Dimmable with ELV and/or LED compatible wall
dimmer switches.
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY
A QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
G
E
Q
J
K
M
O
N
F
P
H
I
Screw Driver