Work Light User Manual

18
GEORG FISCHER +GF+¹
6.6 Cutting and bevelling the pipe
This procedure combines cutting and bevelling
of the pipe. When cutting and bevelling simul-
taneously, turn the pipe cutter more slowly
around the pipe that you would for cutting
alone, as two tools are used at the same time.
Put on safety goggles before cutting.
!Connect the pipe
cutter to the mains.
!Apply saw blade lu-
bricant to the saw
blade teeth/cutting
surface.
³ 1 m
³ 1 m
Repeat the lubrication every three cuts.
If in contact with drinking water or
foodstuffs, use only Georg Fischer
lubricating gel.
!Mark the cutting
location on the
pipe.
!Insert the pipe in the
vise.
!Push the marked
cutting location over
the saw blade.
!Clamp the pipe in
the vise.
Use a pipe support for pipes that are more
than 1 m long.