Work Light User Manual

14
GEORG FISCHER +GF+¹
6.4 Using stops
Length gauge up to 250 mm
!Mount the length
gauge (1).
!Swing the stop (2) in
to the middle of the
pipe and engage.
!Release the cross
knob (3).
!Set to the desired
length. Use the scale.
!Tighten the cross
knob.
!Push the pipe for-
wards up to the
stop and clamp.
!Swing the stop clear.
!Cut the pipe.
Length gauge over 250 mm
!Mount the length
gauge (1).
!Swing the stop in to
the middle of the
pipe.
!Use a yardstick to
extend the stop to
the desired length.
!Push the clamp (2)
up against the
housing and turn it
so that it is in
contact with the
work bench.
2
3
1
1
2