Users Manual
NUSITE
NUSEIS
Geophysical Technology Inc NuSite Page | 45
o The number of total unit logs that are present in the database and how many are not
synchronized with the NuScribe database.
o Number of work orders.
o Number of user profiles from the last user synchronization of the device.
• Synchronize All will show the date and time of the last synchronization with the NuScribe
database. Tapping on Synchronize All will initiate a complete synchronization.
o If this is the first synchronization since the software was installed or updated, Last
Update will show <Never>
Figure 46
o There are 5 categories of information that are synchronized between the NuSite
database and the NuScribe database.
▪ Work Orders – synchronizes Work Orders that were setup in
NuScribe.
▪ User Profiles – synchronizes user profiles that are setup in NuScribe.
▪ Unit Scans – unit scans that are present in the NuSite database are
synchronized to the NuScribe database.
▪ Receiver Points – synchronizes receiver point information from the
NuScribe database to the NuSite database.
▪ Map Image Definitions – adds map layer images that have been
loaded into NuScribe.
o Each category is synchronized in order. The spinning ring will turn orange indicating
the category is currently synching. The other categories will show waiting and the
ring will be grey.
o Successful synchronization will have the orange ring turn into a green checkmark for
good synchronization or a red circle with a white x indication a synchronization
failure, usually followed by an error message.