User's Manual

Manual MN71-082 Rev - 15
Depth Measurement
Before running a successful survey, you need to know two things:
1) How far down do you want to see.
2) What type of soil you are over. (i.e. what dielectric value should be set.)
If you don’t know 2), we have tricks to help get you this information.
This is the information used to fill the CONFIG table (Figure 10).
Figure 10: Configuration Page
A typical matrix is shown above. However, if you happen to know the exact soil type, then you can enter
the exact dielectric value in. You can also get the soil dielectric by surveying over a pipe and running the
auto-target software (more on this later).