User Manual
Table Of Contents
- Limited Warranty, Limitations Of Liability And Restrictions
- Garantie limitée, limites de responsabilité et restrictions
- FCC Notice (for U.S. Customers):
- (a) UWB imaging systems require coordination through the FCC before the equipment may be used. The operator shall comply with any constraints on equipment usage resulting from this coordination.
- Or
- Frequency Coordination Branch, OET
- ATTN: UWB Coordination
- Canadian Requirements for RSS-220
- Canadian Requirements of RSS-220 for Ground Antennas
- Canadian Requirements of RSS-220 for Hand-held Antennas
- Canadian Requirements of RSS-220 for Search and Rescue Antennas
- Table of Contents
- Section 1: Introduction 1
- StructureScan™ Mini XT 2
- Section 2: Getting Started 3
- Section 3: Using ScanEZ Mode 5
- Section 4: Using the Scan3D App 10
- Section 5: Using the ScanMax App 14
- Section 6: Calibrating for Depth in the ScanMax App 20
- Section 7: Using the DualScan App 23
- Section 8: File Management 26
- Setting up Your Laptop/PC and Data Transfer 27
- Launching and Navigating the Software 28
- Viewing and Processing the Data 30
- Processing the Data 32
- Ribbon Options 34
- Home Ribbon Options 34
- 3D Volume Options Ribbon 40
- Chapter 1: Using the StructureScan Mini XT
- Section 1: Introduction
- StructureScan™ Mini XT
- Section 2: Getting Started
- Section 3: Using ScanEZ Mode
- Section 4: Using the Scan3D App
- Section 5: Using the ScanMax App
- Section 6: Calibrating for Depth in the ScanMax App
- Section 7: Using the DualScan App
- Section 8: File Management
- Chapter 2: Using RADAN for StructureScan Mini
- Setting up Your Laptop/PC and Data Transfer
- Launching and Navigating the Software
- Viewing and Processing the Data
- Processing the Data
- Ribbon Options
- Home Ribbon Options
- 3D Volume Options Ribbon
- Appendix A: The Dielectric Constant
- Appendix B: Data Interpretation and Examples of Common Features
- Appendix C: Technical Specifications
- Appendix D: Accessories
- Appendix E: Labeling
Geophysical Survey Systems, Inc. StructureScan™ Mini XT
Manual
MN 70-813 Rev C 49
Appendix D: Accessories
There are a number of accessories available for the StructureScan Mini XT. Accessories include extra
batteries, replacement chargers, and replacement transit cases. These are offered as an additional
purchase. Please contact your local representative or GSSI Sales for additional information at
sales@geophysical.com
Extension Pole with Six-Button Remote
The extension pole replaces the handle and allows easier use
overhead or scanning long distances on the floor. The grip of the
pole has a keypad which replaced all of the functionality of the
standard Mini XT handle. The GSSI part number for the pole is
FGSSX-POLE.
Assembly:
1 Using the tool provided with the Mini XT, loosen the four
(4) screws at the base of the Mini XT’s handle.
2 Lift the handle off of the Mini XT and set aside, taking care
not to damage the gold-toned contacts on the underside of
the handle.
3 Set the pole’s connection plate on the Mini XT on to where
the handle base was and gently tighten the four (4) screws to secure.
Take care not to cross-thread the screws.
Extension Pole Transit Case
The pole transit case is for protecting the extension pole while travelling or not in use. It contains a
custom foam insert to protect the pole from damage. The GSSI part number for the pole transit case is
FGSSXT-POLECASE.
Pole transit case (Extension Pole sold separately)