User's Manual
Table Of Contents
- Front/Top View
- Back View
- Before collecting any data, configure your Mini HR for 2D or 3D data collection by pressingSystem Menu Options
- Date/Time: Configuring Date and Time
- Configuration: Configuring Orientation, Language, Units, Laser, and Sound
- The Mini HR will then shut down after calibration and will require a re-startClearing Storage: Deleting Saved Data
- Deleting All Projects or Deleting Specific Projects
- Scan Density: Selecting the Scan Density
- Backlight: Setting the Brightness of the Mini HR Backlight
- Save Prompt: Whenever Saving, Have the System Prompt You to Save or Save Automatically
- Collect Menu Options
- Project: Saving Files to a Specific Project
- Depth: Selecting the Depth Where You are Scanning
- Dielectric: Selecting the Approximate Dielectric of the Area You are Scanning
- Auto target: Allowing the Mini HR to Automatically Pick Your Targets
- Display: While Collecting Data, Display Data Only or Data + O-Scope
- Color: Choosing the Colors You Want Displayed During Data Collection
- Collecting Data and Marking Your Targets
- Playback Menu Options
- Project: Selecting a Specific Project to Select a Specific File to Playback
- Auto Depth: Automatically Adjusting Depth Scale
- Auto Target: Allowing the Mini HR to Automatically Pick Your Targets
- Auto Gain: Allowing the Mini HR to Automatically Configure the Gain
- Display: While Viewing Data, Display Data Only or Data + O-Scope
- Color: Choosing the Colors to Display during Data Collection
- Playing Back the Selected File
- Configuring the StructureScan Mini HR for 3D Collection
- Date/Time: Configuring Date and Time
- Configuration: Configuring Orientation, Language, Units, Laser, and Sound
- Calibration: Auto Calibrations for Surface and Brightness
- Clear Storage: Deleting Saved Data
- Deleting All Projects or Deleting Specific Projects
- Backlight: Setting the Brightness of the Mini HR Backlight
- Save Prompt: Whenever Saving, Have the System Prompt You to Save or Save Automatically
- Collecting 3D Data
- Collect Menu Options
- Collect: Collect 3D Grid
- Playback: Processing and Drawing the 3D Grid
- Modes
- Laser Information: General
- Laser Information: Specific for the StructureScan Mini HR
- Laser Information: Projected Laser Beam Layout
- Laser Information: Label Placement Diagrams
Quick Start Guide StructureScan Mini HR
Geophysical Survey Systems, Inc.
36
Modes
You may press the Enter button to toggle between different modes for display and edit purposes.
They are: Depth Slice Mode, Cursor Mode, Color Mode, and Select Profile Mode.
Depth Slice Mode
1
The initial display will be the Full Range of the grid. Pressing the Ï from the Full Range will
decrease the range depth by ½ inch (1.27 cm) increments. Pressing the Ð will slice down
through the image in ½ inch (1.27 cm) increments. Note the top of the screen. It will display
the depth of the slice or the total depth of the slice.
2 Press Í and hold for two seconds to Exit.
3 Press Î to save the image as a .bmp file.
4 Press to toggle to Cursor Mode.
Cursor Mode
This will display crosshairs on the data so that X and Y coordinates located at the top of the screen
may be noted as the location of a target.
1 Press Ï Ð buttons to move the crosshair in the Y Direction.
2 Press Î to change the menu to the X Direction Mode so that you may move the crosshair in
the X Directions by pressing Ï Ð.
3 Note the X and Y coordinates at the top of the screen as you move the cross hairs.
4 Press Í to set a mark at the location of the crosshairs.