User's Manual
Table Of Contents
- Front/Top View
- Back View
- Before collecting any data, configure your Mini HR for 2D or 3D data collection by pressingSystem Menu Options
- Date/Time: Configuring Date and Time
- Configuration: Configuring Orientation, Language, Units, Laser, and Sound
- The Mini HR will then shut down after calibration and will require a re-startClearing Storage: Deleting Saved Data
- Deleting All Projects or Deleting Specific Projects
- Scan Density: Selecting the Scan Density
- Backlight: Setting the Brightness of the Mini HR Backlight
- Save Prompt: Whenever Saving, Have the System Prompt You to Save or Save Automatically
- Collect Menu Options
- Project: Saving Files to a Specific Project
- Depth: Selecting the Depth Where You are Scanning
- Dielectric: Selecting the Approximate Dielectric of the Area You are Scanning
- Auto target: Allowing the Mini HR to Automatically Pick Your Targets
- Display: While Collecting Data, Display Data Only or Data + O-Scope
- Color: Choosing the Colors You Want Displayed During Data Collection
- Collecting Data and Marking Your Targets
- Playback Menu Options
- Project: Selecting a Specific Project to Select a Specific File to Playback
- Auto Depth: Automatically Adjusting Depth Scale
- Auto Target: Allowing the Mini HR to Automatically Pick Your Targets
- Auto Gain: Allowing the Mini HR to Automatically Configure the Gain
- Display: While Viewing Data, Display Data Only or Data + O-Scope
- Color: Choosing the Colors to Display during Data Collection
- Playing Back the Selected File
- Configuring the StructureScan Mini HR for 3D Collection
- Date/Time: Configuring Date and Time
- Configuration: Configuring Orientation, Language, Units, Laser, and Sound
- Calibration: Auto Calibrations for Surface and Brightness
- Clear Storage: Deleting Saved Data
- Deleting All Projects or Deleting Specific Projects
- Backlight: Setting the Brightness of the Mini HR Backlight
- Save Prompt: Whenever Saving, Have the System Prompt You to Save or Save Automatically
- Collecting 3D Data
- Collect Menu Options
- Collect: Collect 3D Grid
- Playback: Processing and Drawing the 3D Grid
- Modes
- Laser Information: General
- Laser Information: Specific for the StructureScan Mini HR
- Laser Information: Projected Laser Beam Layout
- Laser Information: Label Placement Diagrams
Quick Start Guide StructureScan Mini HR
Geophysical Survey Systems, Inc.
26
3 Press Î to return to the previous menu.
Calibration: Auto Calibrations for Surface and Brightness
1 Highlight Calibration and press .
a) Hold the Mini HR upside down about 1 meter (3 ft) from any surface.
b) Press . The Auto-Calibration will take several seconds.
2 Press Î to return to the previous menu.
Clear Storage: Deleting Saved Data
A project is a folder which holds individual files.
1 Highlight Clear Storage and press .
2 At the bottom of the screen, a new set of options is displayed.