User Manual

ManualsBrandsGeophysical Survey Systems ManualsElectronics5106 Antenna

Geophysical Survey Systems, Inc. Model 5106 Antenna

System Settings and User Notes

Manual MN30-191 Rev - 1

Model 5106 Antenna

System Settings and User Notes

We Provide Complete Survey Solutions

Geophysical Survey Systems, Inc.

13 Klein Drive, P.O. Box 97

North Salem, NH 03073-0097

Phone: (603) 893-1109 / FAX: (603) 889-3984

www.geophysical.com

sales@geophysical.com

Summary of content (5 pages)

PAGE 1
Geophysical Survey Systems, Inc. Model 5106 Antenna System Settings and User Notes Model 5106 Antenna System Settings and User Notes We Provide Complete Survey Solutions Geophysical Survey Systems, Inc. 13 Klein Drive, P.O. Box 97 North Salem, NH 03073-0097 Phone: (603) 893-1109 / FAX: (603) 889-3984 www.geophysical.com sales@geophysical.
PAGE 2
Limited Warranty, Limitations Of Liability And Restrictions Geophysical Survey Systems, Inc. hereinafter referred to as GSSI, warrants that, for a period of 12 months from the delivery date to the original purchaser, GSSI's products will be free from defects in materials and workmanship. EXCEPT FOR THE FOREGOING LIMITED WARRANTY, GSSI DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
PAGE 3
GSSI is required to notify customers of the following restrictions. However, GSSI and other GPR manufacturers have challenged these regulations. This device complies with part 15 of the FCC Rules: Operation is subject to the following conditions: 1. This device many not cause harmful interference, and 2.
PAGE 4
Model 5106 Antenna The Model 5106 antenna has greatly improved resolution performance over previous GSSI midfrequency antennas, such as the Model 3105 (300 MHz). The Model 5106 can be used in continuous, survey wheel or static stacking modes. The Model 5106 can only be used with a “deadman” switch with the SIR-20 or SIR-3000 control units.. These systems are designed to drive the antenna at its maximum rated pulse repetition frequency of 100 KHz.
PAGE 5
To test that you have the correct position, raise the antenna off the ground and you will observe on your system that the antenna transmit pulse will separate from the reflection from the ground. The higher that you raise the antenna, the further apart will be the two pulses. To assure that the direct coupling pulse (time zero) is recorded the user should place the signal Position servo in the manual mode.