User's Manual

Quick Start Guide Utility Scan 350HS

3 Connect the two pieces of the H2 Mounting Unit together using the 4 screws and hex nuts. You may use a

guiding tool (i.e. screw driver) to guide the hex nuts into the hex holes. Attach the H2 Mounting Unit and the

Cable Guide to the handle.

4 Remove the 4 screws between the arrows of the antenna. Attach the Battery Mounting Bracket to the antenna,

using the 4 screws, as shown (Notice the location side of the large tab). Torque to 8-10 inch/pounds. Insert the

350HS Antenna into the capsule. NOTE THE POSITION and THE DIRECTION of the antenna in the capsule.