User's Manual

User Guide LifeLocator

III+ System

Section 3: Expert Mode

Access the Expert Mode from the Main menu by using the Up/Down arrows to highlight EXPERT MODE then press the

Enter button or simply tap EXPERT MODE on the Control Unit screen.

WAVEFORM is a diagnostic screen. A properly functioning Sensor should show a waveform pattern (see below).

LINESCAN enables viewing radar data results in real time that may indicate breathing or motion as an alternative to the

basic Run screen (squares and circles). The screen is rotated 90 degrees in order to display data more effectively. The

margin on the right displays the approximate distance of any motion signals. The margin on the left permits several user

selected options:

• RESTART: terminates current search cycle and starts

another.

• COLOR: a display palette of five colors patterns are

available. Typically number 3 and 4 give best results.

• GAIN: may be adjusted from 1 to 256 depending on the

make up of the material being searched. Best results are

normally obtained at settings no higher than 32.

• LIGHT: the intensity of the backlight can be

increased/decreased.

Expert Mode – Target Playback

While in the Expert Mode, previous search cycles may be played back showing radar data

collected at the time. From the Expert Mode screen, use the Up/Down arrows on the Control

Unit to highlight Playback Data or simply tap PLAYBACK DATA on the Control Unit

screen.

As in normal Playback Mode, the SELECT FILE screen appears. Highlight or tap the chosen

search file.

• Similar to the normal Playback Mode, RESTART, COLOR, and GAIN are user

selectable choices. An additional choice allows the user to control the speed of

playback from 1

(slowest) to 5 (fastest).

• Search files performed in normal mode (circles and squares) but later

played back in Expert Mode have the ability to display the circle or

square icons overlaid on the radar data if

Target Playback (a choice on the left margin) is turned on. Search

files performed under Expert Mode cannot show the icons and the

Target On button will be grayed out.

• To return to the Expert Mode menu press OK. To return to the MAIN

menu, press ok once again.

UltraVision Security Systems, Inc. 6