User Manual

Total Station Manual
197
Time Setting
2.4 Firmware Upgrade
Warning
˖
The following functions must be carried out under the guidance of
professionals, if the operation is wrong, it may lead to the instrument can’t
work properly!
This function is prepared for the users to upgrade theinstrument software.

Input PIN code(82543), and then press key ENT,the instrument will be turnedoff.

Connected to the computer through a serial cable, after installing the correct driver
premise, open a HyperTerminal software, configure the correct serial port, it will
"bits / sec" is set to 115200, "Data Flow Control" is set to "None" and press OK.