User Manual

Total Station Manual
160
ĸ
There are several
methods to obtain the
Pt which is used for
Measure Line&Offset
A: Enter point name,
then press [F1](ALL)
to define the Pt.
Input
point
name
+
[F1]
A: Get the target point by measure.
$//
>0HDVXUH/LQH2IIVHW@
',67 5(& Ę
ٿ㖞⁑ᔿ
/LQH˖P
2IIVHW˖P
7+˖P
3W˖
˖P
B: Input point name,
Press [F2](DIST) +
[F3](REC) to save the
Pt, the saved result will
be directly put into
calculation.
[F2]
+
[F3]
B: Get the target point by DIST+REC.
$//
>0HDVXUH/LQH2IIVHW@
',67 5(& Ę
ٿ㖞⁑ᔿ
/LQH˖P
2IIVHW˖P
7+˖P
3W˖
˖P
C: Input point name,
press [F4](ɓ)toshiftto
subscript function,
press [F1](Find) to
check whether this
point was existed, if not
exist, then should
firstly input or
measuring this point's
coordinate.
Input
point
name
+
[F4]
+
[F1]
+
[F4]
C: Input the name of the point and find
whether it is in memory.
D: Press [F2](List) , in
[Find Pt.] screen,
search the known
points in job through
[
Ʒ
]\[

] and press
[F4](OK) to select.
[F2]
+
[F4]
D: Select the point by list in the
instrument.