User Manual
Total Station Manual
159
$//
>5HI$UF@
',67 5(& Ę
ٿ㖞⁑ᔿ
)LQG /LVW &RRUG Ę
('0
К
7+˖P
˖P
˖P
6WDUW˖
0HDVXUHWRVWDUW3RLQWʽ
Ć
1
AZ1 and AZ2 are start point, end point tangent azimuth respectively . If the input
data is not in conformity with the requirements, the instrument will report "invalid
target data, please input again", you can select "yes" or press the [ESC] to return to
the interface of starting point measurement, start to define arc.
Ć
In above operation, press [ESC] to return to previous menu.
z Measure Line&Offset
Steps Key Display
ƻ
1
Using method of
the "Centre, Start
Point" or "Start&End
Pt, Angle" defines the
reference arc, entering
the [Reference
ARC-Main Page], and
press [F4] (DIST) to
Measure Line&Offset
[F4]
>5HIHUHQFH$ 5&0DLQ3DJ H@
&WU3W
6WDUW
(QG3W
5DGLXVP
1HZ$UF 0HDV
$//
>0HDVXUH/LQH2IIVHW@
',67 5(& Ę
ٿ㖞⁑ᔿ
/LQH˖P
2IIVHW˖P
7+˖P
3W˖
˖P