User Manual

Total Station Manual
75
ƻ
3
A:
The program searchs the
point name in the job and
show the result dialog.
The match points will be
listed, press [F4](OK) to
identify selected point and
back to Stakeout screen.
(If the input is wildcard
"*", the program will
show all the points of the
current job.)
Ć
2
B:
If there is no match point
in the job, the program
prompts“Pt. not
found!”.Andthengoin
Find Point In Job screen.
User can input a point or
select a point from
another job and then back
to Stakeout screen.
ƻ
4
After finishing setting
stakeout point, start
staking out.
Ć
1
: The settings of job, station and orientation have been elaborated in detailIn the
previous chapters, here is no longer repeat. Refer tochapters“Setting TheJob
ǃ
Setting The Station
ǃ
Setting The Orientation”.
Ć
2
: Unlike the other place's points list, the stakeout points are ordered by time.In the
stakeout points list, the newest point is at the back and the fix point is in the front
ofmeasured point. But in the other points list, the newest point is at the back and
the measured point is in the front offix point.