User Manual

Total Station Manual
60
2.1 Select the coordinate from memory [Find]
Steps:
1
ǃ
Select the coordinate from memory.
2
ǃ
Input instrument height.
3
ǃ
[OK] Set station.
Steps Key Display
ƻ
1
Press [F2] in the
Pre-Settings screen. Then enter
the Set STA function.
[F2]
ƻ
2 Input the name of the station
point which exists in the job and
then press [ENT].
Ć
1
Input
point
name
+
[ENT]
ƻ
3 Press [F1](Find):
A: If the input name exists in
the current job, there will show
the screenas shown on the right
figure. The multiple points with
the same name will be sorted by
type.
B: If the input name doesn’t
exist in the current job, the
program prompts the message
“Pt. not found”. Then enter the
[Find Pt.] screen.
There can also select point from
other jobs and set it as the
station point. Input the point
name and press [F4](Find). If
A:
B: