User Manual

Total Station Manual
50
ƻ
4
After finishing setting
up the fixpoint, the height
of fixpoint is displayed in
the screen and press
[F1](ALL)or
[F2](DIST)+[F3](REC) to
start to measure and
calculate, the height of
station is calculated.
[F1]
or
[F2]
+
[F3]
ƻ
5
In the interface of
[Height Transfer Result],
pressing [PAGE] to switch
the display of result
information.
Press [F1](Add PT) to add
a new point and to start a
new measurement.
Press [F3](Back) to back to
measure the current point
again.
Press [F4](OK)to enter the
interface of [Set STA HO].
[PAGE
]
ƻ
6 Pressing [F1] to back to
the interface of [Height
Transfer Result].
Press [F2] to set the height
of staton to the old value
Press [F4] to set the height
of station to the new value
which calculated after
Height Transfer.
Press [F3] to set the height
of station to the average of
the old value and new
vlaue