User Manual

Total Station Manual

5 Display the result of

cylinder offset.

2.3 Angel Offset

Angle Offset is used to measure the points which are intervisible but hava no

reflector and can’t set up the prism. The basic principle is making the target point and

measurement point in the concentric circles whose center is station point, then

measuren the position information of station point and measurement point and the

angle offset of station to target point, thus can calculate the coordinate of target point.

Set the measurement point P in the place where is as far as possible to close the

left or right of target point C, and make the distance between measurement point P

and station point A and the distance between station point A and target pointCare

approximately equal.

Steps Key Display

In the program of

Q-Survey, press [FNC] to

enter the menu of Function,

then pressing [F2] to enter

the program of Offset.

[F2]