Product Manual

Introduction
Congratulations on the purchase of a GeoMax Zoom40 series instrument.
This manual contains important safety directions as well as instructions for setting up the prod-
uct and operating it. Refer to "1 Safety Directions" for further information.
Read carefully through the User Manual before you switch on the product.
The model and serial number of your product are indicated on the type plate.
Always refer to this information when you contact your agency or GeoMax authorised service
workshop.
•
Windows is a registered trademark of Microsoft Corporation in the United States and other
countries
All other trademarks are the property of their respective owners.
Description
General This manual applies to Zoom40 instruments. Where
there are differences between the models they are
clearly described.
☞
The appearance of the products is sub-
ject to change without notice. The
appearance of the actual product may
vary slightly from the product shown in
the illustrations.
Telescope
•
Measuring with P modes: When measuring
distances to a reflector with Electronic Dis-
tance Measurement (EDM) mode “P”, the tele-
scope uses a wide visible red laser beam,
which emerges coaxially from the objective of
telescope.
•
Measuring with NP modes: Instruments
that are equipped with a reflectorless EDM
additionally offer the EDM mode “NP”. When
measuring distances with this EDM mode, the
telescope uses a narrow visible red laser
beam, which emerges coaxially from the
objective of telescope.
NOTICE
Purchase
Product identification
Trademarks
Validity of this manual
2