Product Manual

FACTORY RESET

CAUTION: To prevent data loss, back up all user data to an SD card or external memory device before

performing an upgrade or factory reset.

To Perform a Factory Reset:

1. Perform a Hard Reset

2. The terminal will reboot automatically and you will see first booting screen

3. menu.

5. When the clean boot is completed, do a touch calibration.

4.20 Suspend Mode

terminal is programmed to go into Suspend Mode automatically when inactive for a specified period of time.

You can set this time period in the Power setting.

To suspend and resume operation, press the Power button.

NOTE: You should always put the terminal in Suspend Mode when you change the battery pack; see Changing the Battery

Pack on paragraph 4.18.

TROUBLESHOOTING SUSPEND/RESUME

If the terminal does not wake when you press the Power button, the main battery might be too low to resume

operation. To check, remove the battery and install a fully charged battery or connect the terminal to a

Terminal charging peripheral.

4.21 Memory Allocation

You can verify file storage and program memory in System Properties.

1. Tap Start -> Settings -> System -> Memory tab.

4.22 Care and Cleaning of the Products

When needed, clean the image engine window and the LCD display with a clean,

non-abrasive, lint-free cloth. The terminal can be cleaned with a damp cloth.