Product Manual

Zenius5
|
22
Operation
4.1.3 Charging the
Battery
The following advice is only valid for battery charger, power adapter and car adapter.
WARNING
If you open the product, either of the following actions may cause you to receive an electric shock.
Touching live components
Using the product after incorrect attempts were made to carry out repairs
Precautions:
Do not open the product. Only GeoMax authorised service centres are entitled to repair these products.
The following advice is only valid for batteries, power adapter or docking station.
WARNING
The product is not designed for use under wet and severe conditions. If unit becomes wet it may cause
you to receive an electric shock.
Precautions:
Use the product only in dry environments, for example in buildings or vehicles. Protect the product against
humidity. If the product becomes humid, it must not be used!
Charge battery step-
by-step
4.2 Inserting
and Removing a
SIM Card and
SD Card
Keep the card dry.
Use it only within the specified temperature range.
Do not bend the card.
Protect the card from direct impacts.
Failure to follow these instructions could result in data loss and/or permanent damage to the card.
CAUTION
Always ground yourself to remove any static charge before touching the circuit board. The electronic
devices are sensitive to static electricity.
Precautions:
1) Only experienced personnel should open the mechanical housing of the device.
1.
Connect the AC power adapter to the Zenius5 and to an A/C plug.
Alternative:
Connect the Zenius5 to a computer using the data transfer cable. Note: The data transfer
cable has a lower charging capability than the AC power adapter.
2.
The battery starts charging. The Power LED flashes green to indicate the charging.