Product Manual
Table Of Contents
- Introduction
- Table of Contents
- 1 General Information
- 2 How to Use the Locator
- 3 How to Use the Transmitter
- 4 How to Use the Conductive Rod
- 5 How to Use the Signal Clamp
- 6 How to Use the Property Connection Set
- 7 How to Use the Sonde
- 8 Care and Transport
- 9 Safety Directions
- 10 Technical Data
- 11 International Limited Warranty
- Appendix A Functional Checks
- Appendix B World Frequency Zones
- Index
EZiSYSTEM, How to Use the Locator 39
GPS Search Mode (i700, i750 & i750xf)
A GPS search mode is activated as part of the start up test allowing the internal GPS
module time to search for a GPS position. GPS search mode is active following the start up
test even if the locator is off, the search mode will stop when a GPS position is obtained or
a 12 minute search period has elapsed.
GPS search mode does not affect the locator's performance and the locator can be used as
normal throughout this search mode.
When retrieving log files from the i700, i750 & i750xf "P.C" must be selected from the
"COM" setting as described in section 2.3 Locator Setup and Information.
COM Setting Options
PC: Enables Bluetooth communication to Logicat Software
BT1: Enables Bluetooth option 1 (refer to section 2.6)
BT2: Enables Bluetooth option 2 (refer to section 2.6)
GPS: Switches GPS on following use with BT1 or BT2 settings
BT1 and BT2 connections will be maintained for a three hour period when selected, during
this period the GPS will be off. The GPS will automatically activate after the three hour
period has elapsed or GPS is selected from the COM Setting.