Zoom3D_usermanual

60 - Checkup and measuring of distances
In the camera view are visualized the measured points in Red if they are below the reference plane; in
Blue if they are over the reference plane.
To delete visualization of all measured points press the button Delete points.
Checkup and measuring of distances
The command allows to perform measures of distances between two points or between a
point and a reference element as a line, a circle or an arch; measuring of distances can be
made also with the command Measure but in this case it’s available a specific command
and thoroughly dedicated to this purpose.
Horizontal distances
1. Measure first point
2. Measure second point
In the lower part of the window they are visualized measured values:
Horizontal distance
3D Distance
Height difference
Slope
It’s possible to select between two measuring modes:
Single: it’s calculated the distance between the first point and the point just measured
Multiple: it’s calculated the progressive distance between the first point and all the points
measured after.
It’s possible to activate continuous measuring allowing to change measuring direction while Zoom3D
measures.
Vertical distances
1. Measure first point
2. Measure second point
In the lower part of the window are visualized measured values:
Distance on vertical plane between the two points