Zoom3D_usermanual
Insides measuring utilities - 57
a. Calculated by the measure of the distance between two points to measure; select the item
Measure (2 points) and then measure two points; the distance between the two points will be
used for calculation of the parallel line.
b. Determined by the distance of a reference point to measure referring to the reference line;
select the item Measure by line and then measure a point; the distance between the measured
point and the reference line will be used for calculation of the parallel line.
c. Inserted manually: select the item Insert offset. Type the offset distance to use for calculation
of the parallel line
4. Measure approximately the position on which you should find the parallel line .
5. XPAD 3D will determine automatically the exact position. If position is found the laser spot lamps.
Offset: Press this button to modify the distance to use for calculation of the parallel line.
Marking of heights
The command Marking of heights allows to determine the position at different heights
starting by a reference height.
1. Indicate the absolute height corresponding to reference point
2. Measure the point representing the reference height
3. Indicate the Absolute height you want to stake
4. Measure approximately the vertical surface on which you want determine the position of the
absolute height
5. XPAD 3D will determine automatically the exact position If position is found the laser spot lamps.
New height: Press this button to insert a new absolute height to stake.
Distance & Offset
The command Distance & Offset allows to determine new positions and distances related
to a starting point on vertical surfaces. Having a starting point it’s possible to set a relative
distance horizontally and a relative distance vertically and Zoom3D will position itself
exactly on requested point.
1. Measure the starting point
2. Insert desired movements vertically and horizontally