Zoom3D_usermanual
56 - Plumb point
Insides measuring utilities
The set of utilities below is particularly useful in insides surveys with Zoom3D.
Plumb point
The command Plumb point allows to determine, for the measured point, the corresponding
plumb point (toward the top or toward the bottom).
1. Measure the point of which you want determine the corresponding plumb point
2. Measure approximately the position on which should be the plumb projection .
3. XPAD 3D will determine automatically the exact position. If position is found the laser spot lamps.
Level
The command Level allows to bring a reference height on every other surface.
1. Measure the point representing the reference height .
2. Measure approximately the surface on which you want to bring the reference height .
3. XPAD 3D will determine automatically the exact position. If position is found the laser spot lamps.
Parallel line
The command Parallel line allows to determine parallel lines to a reference line on every
surface.
1. Measure first point of the reference line .
2. Measure second point of the reference line .
3. Now it’s necessary to set the distance at which to create the parallel line. The distance can be: