Zoom3D_usermanual

52 - Stakeout of points with offset
next point to stake.
Stakeout of points with offset
1. Select the point to stakeout from the graphic window.
2. It’s possible to set a stakeout distance from point; in this way it will be possible to stake every
position at the preset distance from the reference point; Press the button .
3. Set the offset distance; Press Measure to measure the offset distance; measure the point that
will be used to calculate the offset distance . The offset distance will be the same as the
distance between the reference point and the point just measured.
4. Press Start.
5. Press to start the measure; it’s possible also to use the continues measure .
6. In the lower part of the window are visualized several information: information specifying if
you must go away or closer to reference point to reach the preset offset distance, the height
difference.
7. Press Accept to complete stakeout with offset from the reference point selected.
Stakeout of lines
1. Select the line to stakeout from the graphic window.
2. It’s possible to set an offset distance; this way it’s possible to stake a parallel line to the
reference line; Press the button .
3. Set the offset distance; Press Measure to measure the offset distance; measure the point that
will be used to calculate the offset distance . The offset distance will be the same as the
distance between the reference line and the point just measured. It’s possible to apply the
offset distance on the Left or on the Right of the reference line.
4. Press Start.
5. Press to start the measure; it’s possible also to use the continuous measure .
6. In the lower part of the window are visualized different information: the distance from the line
to stakeout, the height difference, the position referring to the line and the distance referring to
first point of the line.