Zoom3D_usermanual

Measure - 39
6. Press Accept to save the line
Calculation of points along a line
This command allows to calculate a point along a reference line and at a distance to it.
1. Select a line from the graphic window
2. Press the button Tools
3. Select the item Distance & Offset
Starting point
The point to insert can be calculated by the starting point or by the ending
point of the reference line.
Direction
The point can be inserted along the line or on its left or right.
Distance
Distance to which inserting the new point; the distance is referred to the
starting or ending point of the line.
Angle
If it has been chosen the operation insert Right/Left it’s possible to specify the
angle of insertion of the point referring to the reference line. An angle of 90°
indicates that the point is inserted perpendicularly to the line.
Offset
If it has been chosen the operation insert Right/Left it’s possible to specify the
distance at which to insert the point referring to the reference line.
4. It’s visualized the point calculated
5. Press Accept to save the point
Measuring edges
Measuring rooms it’s fundamental the measure of the edges between the walls, the edges between
walls and ceiling and of edges between walls and pavement; the sharp collimation of these points with
the room can be difficult due to uniformity of the color of the walls or not favorable light conditions. To
solve this problem it has been introduced the possibility to determine automatically these elements
through the recognition of the surrounding plans defining the point to measure.
This option is obviously available when it has been set the laser spot as measuring mode. To set the
automatic measuring of the edges press the button located just over the button .
Direct measure: it’s measured the point collimated by the camera.
Top line: it’s determined and measured the intersection point between the
wall and the ceiling
Bottom line: it’s determined and measured the intersection point between
the wall and the pavement
Top corner: it’s determined and measured the upper edge resulting by the
intersection of two walls and the ceiling.