Zoom3D_usermanual
32 - Units of measure and precision
Settings
The software is subject to several parameters and options that are fully customizable by
the operator.
Units of measure and precision
The page allows to set the units of measure and the precisions to use for every kind of data.
Visualization filters
The page is divided in two sections, one for the camera and one for the graphic view; for every section
it’s possible to set the data to keep visible in the corresponding view.
Tolerances
The page allows to set the tolerance to use in calculation of the relocation and in the stakeout
procedures.
Relocation: if the calculation of the relocation gives an error higher than the tolerance, a warning is
visualized.
Stakeout: when the stakeout distance is lower than the preset tolerance, XPAD 3D announces that the
point has been reached.
WiFi
If using the WiFi is difficult in particular environment or places, it can be a solution to change the
communication channel.
The button WiFi Analyzer allows to di check the channels occupation by all WiFi devices. Select a free
and the most “far” from others channel possible.
Disconnect the USB cable and try again the WiFi communication.
Language
XPAD 3D can be used in different languages. Select the desired language from the list. To use XPAD
3D with a new language it’s necessary to close the software and re-start it.