Product Manual

Operation Zenith35 Pro | 17
Equipment setup step-
by-step
4.2.4 Fixing the handheld to a holder and pole
Components of the
ZHR200 holder
Fixing the handheld to
the holder step-by-step
Step Description
1. Attach the ZHR200 holder to the ZPC200 pole. Refer to "4.2.4 Fixing the handheld to a holder
and pole".
2. Clip the handheld into the holder and lock it by tighten the screw on the holder.
3. Turn on the handheld.
4. Insert the battery into the instrument.
5. Connect the UHF antenna to the instrument. The connection is only required when using the
internal radio.
6. Press ON/OFF key on the instrument for 2 s to switch on the instrument.
7. Screw the instrument to the top of the pole.
8. Connect the handheld to the instrument through Bluetooth.

If RTK corrections are received with the handheld, the handheld must be connected
to the instrument by serial cable.
Clamp
a) Locking pin
b) Tightening screw
c) Pole clamp
Holder
d) Tightening screw
e) Pin
004580_001
a
b
c
d
e
Step Description
1. Insert the pole into the clamp hole.
2. Tighten the clamp with the tightening screw.
3. To attach the holder to the clamp insert the pin into the catch of the clamp while pushing down
the locking pin.
4. Place the handheld in the holder.
5. Tighten the screw of the holder to fix the handheld to the holder.