Product Manual

8 Coding
8.1 Coding
Codes contain information about recorded points. With the help of coding, points can be
assigned to a particular group simplifying later processing.
Codes are stored in codelists, with each codelist supporting a maximum of 200 codes.
Codes are always stored as free codes (WI41-49), that means that codes are not directly linked
to a point. They are stored before or after the measurement depending on the setting made.
A code is always recorded for each measurement as long as the code is displayed in the Code:
field. For a code not to be recorded, the Code: field must be cleared. This can be set to occur
automatically. Refer to "5.1 General Settings".
•
Either, select Survey from the MAIN MENU and press CODING.
•
Or, press FNC when within any application and select Code Library.
REC
To record the code without measurement.
AddLst
To add the entered code to the codelist.
Field Description
Search/New Code name.
After entry, the firmware searches for a matching code name,
and displays these in the code field. If a matching code name
does not exist this value becomes the new code name.
Code List of existing code names.
Comment More remarks.
Text1 to Text8 More information lines, freely editable. Used to describe attrib-
utes of the code.
To each code a description and a maximum of 8 attributes with up to 16 characters each can be
assigned. Existing code attributes, displayed in fields Text 1: to Text 8:, can be overwritten
freely with the following exceptions:
The codelist editor of GGO can assign a status to the attributes.
•
Attributes with status "fixed" are write-protected. They cannot be overwritten or edited.
•
For attributes with status "Mandatory" an input or a confirmation is required.
•
Attributes with status "Normal" can be edited freely.
8.2 Rapid Coding
Only available on Zoom50.
Description
GSI coding
Access
CODE-LIBRARY
Extend / edit codes
Availability
Coding 53