User's Guide

Equipment Setup and Operation
GEOMATE SG7 GNSS USER GUIDE | 2022-04 P a g e | 56
➢ Site Name: Enter the name of the site.
➢ Antenna Height: the measured height value.
➢ Measure way: Antenna Phase Center, Vertical Height, Slant Height
➢ Storage Format: Select the format of the data store.
➢ RINEX Version: OFF, 3.02, 2.11
➢ Start Date: Select Yes or No option to determine whether to auto record start date.
➢ Apply Time: Select Yes or No option to determine whether to auto record apply
time.
➢ Integral Point Store: Select Yes or No option to determine whether to allow
receiver to save data every hour.
➢ Circulating Memory: Select Yes or No option to determine whether to auto delete old
files if the storage space is full.
➢ Repeat Observations: Select Yes or No option to determine whether to turn on to
record a single observation.
➢ Store Location: Internal Storage, External Storage.
➢ Assigned Storage: The assigned memory size of current thread(for example, Record
1) is 10000MB
➢ Observer: Enter the name of observer.
➢ Observer Agency: Enter the name of observer agency.
➢ FTP Push: Decide whether to push the stored files to the FTP server of your choice.
Tap button to save the settings and back to the Log Settings screen.
Also, users can click to abandon the changed settings and back to
Log Settings screen.
Note – To mo dif y data lo g ging parameters, make sure the data log ging sessio
n is switched o ff.
To switch on or off ANY data logging session, tap the ON or OFF button on
the right of the required session.
To delete the recorded files of ANY data logging session, tap the Clear button
on the right of the required session.
To delete the recorded files of ALL data logging sessions, tap the Clear ALL
Accounts button.
5.4.2 FTP Push Settings Submenu
Use this screen to configure the receiver to push stored files to the FTP
server of your choice. Only files that are configured to use FTP push are
transmitted.