User's Guide

Equipment Setup and Operation
GEOMATE SG7 GNSS USER GUIDE | 2022-04 P a g e | 39
Steps:
(1) Keep the receiver fully charged.
If work as a cellular rover station, the SIM card need to be inserted before the batteries.
(2) Screw the receiver onto the pole.
If work as a UHF rover station, the UHF whip antenna need to be connected to the receiver.
(3) Turn on the receiver by pressing the power button for 3 s.
(4) Switch on the data controller and connect it to the receiver.
(5) Use software to configure the receiver as cellular rover or UHF rover mode.
(6) Center and level the receiver more precisely.
(7) Use software to start survey.