User's Manual

LX-80 User Manual
Page 15 of 32
measurement at the same time when the device measures the distance as 6.02m, sensor
height will be calculated as the sum of the two values; 6.02m + 1.34m = 7.36m
In this case the sensor will report 6.02m as measured level and 1.34m as measured
relative level.
4.7. Units
Default measurement unit of the LX-80 is millimeters. It is possible to change the
measurement unit of the device using any communication protocol. Following
measurement units are supported: millimeters, centimeters, meters, feet, inches. When
changing the unit of the device special care must be taken when setting new parameter
values to the device as the device will now use the selected measurement unit for every
measurement and every measurement parameter.