Quick Start Guide

www.geolink.io
2 OpenTracker 2 Quick Start Guide (1.3)
4. Connect Power source
OpenTracker supports 12V/24V nominal power supplies (the full range is 9 – 32 Volts DC).
Please connect Positive (+) terminal to Pin 1 and Negative (–) terminal to Pin 6, as in the picture below.
5. Connect VDET to ignition cable of your vehicle
OpenTracker is preconfigured to go to a low-power mode if the car engine is turned off. The VDET Signal should be
connected to the ignition cable of your vehicle. Any Car Stereo uses the same line to determine if the ignition is
switched on.
If you like to disable this feature you can simply connect it to the positive power source (Pin 1) or change it manually
in software.
6. Start up the tracker
Please ensure to insert the correct data. Wrong information can cause higher data costs and be a source of
connection problems.
Setup APN
Send SMS message to the inserted SIM card number to configure APN for your GSM provider (WAP APN are not
supported):
#pass,apn=APN_NAME
Example:
#pass,apn=internet