User's Guide
9 10
DOC CONTROL: HW-IS-0-0093 DOC REVISION: 200206a
DRAFT DRAFT
GT2 General Maintenance GT2 Replacement
Light amounts of red rust may occur on the optional GT2 metal bezel. This red rust
generally originates from free iron, surface deposits, and general contamination from
weathering and dirt. The presence of light amounts of red rust does not affect the integrity
or function of the product and does not originate from the metal part structure.
GENERAL MAINTENANCE
SOLAR PANEL CLEANLINESS
The GT2 is maintenance free other than general upkeep for cleanliness to maintain
normal device operation and solar capacity. To maintain a long product life and optimal
performance, the GT2 and its solar panel should be kept as clean as possible of dirt, grease,
chemical, and other foreign matter buildups.
The GT2 solar array window will sustain scratching and surface damages over the
lifetime of the product. The GT2 is designed to handle minor surface defects such as these
and still maintain proper device performance over a variety of light levels.
The GT2, however, must be replaced if there are any signs of severe mechanical
damage such as puncturing and cracking of the GT2 housing or window, or crushing of the
unit itself.
When working with or cleaning the GT2, Geoforce recommends to do so outside
of hazardous locations. If this is not possible Geoforce recommends to be mindful at all
times of electro-static discharge (ESD) shock hazards and ESD avoidance by using proper
grounding techniques when touching this device or the asset it is mounted on.
FOR EX RATED PRODUCTS AND HAZARDOUS LOCATIONS SAFETY
METAL BEZEL CLEANLINESS
Warning: Do not dispose of product or batteries in municipal waste areas. Geoforce
recommends to dispose of old retired GT2 devices in acceptable local e-waste recycling
locations.
DISPOSAL NOTICE
1. Record the old GT2 serial number for deactivation.
2. Record the asset name and serial number (on which the GT2 was installed).
3. Remove the old GT2 assembly from its mounting position by loosening and removing
its mounting bolts. Be mindful of dropped object hazards.
4. Separate the GT2 electronics assembly from the protective bezel by hand pressing the
two apart.
5. If unit is installed with VHB refer to the Geoforce VHB installation and removal guide for
removal steps.
STEP 1: REMOVE THE OLD GT2 ASSEMBLY
1. Ensure the mounting bezel and its mounting surface are clean and free of dirt, grease
and chemicals.
2. Install the new GT2 electronics assembly by firmly hand pressing it into its protective
bezel.
STEP 2: REPLACE WITH A NEW GT2 ASSEMBLY
1. Record the new GT2 serial number for activation.
2. Record the asset serial name and number (on which the GT2 was installed).
3. Reinstall the GT2 assembly back onto its mounting location and secure. Geoforce
recommends using new mounting hardware to ensure long service life.
4. DO NOT PAINT OR COVER THE GT2.
NOTE: Doing so may negatively impact product performance and battery life.
STEP 3: REINSTALL THE NEW GT2 ASSEMBLY
Using the pull tab, remove the magnet while outdoors
with a good sky view.
NOTE: Removing the magnet indoors may lead the GT2
to enter Power Save Mode.
STEP 4: INITIALIZE THE GT2
WARNING:
IF YOU DO NOT REMOVE THE MAGNET,
THE GT2 WILL NOT WORK!
TO BEGIN SERVICE
Upon device startup, the GT2 will flash its LED green.