User's Guide

7 8
DOC CONTROL: HW-IS-0-0093 DOC REVISION: 200206a
DRAFT DRAFT
GT2 Plastic Bezel Mounting Guide
For installations with thinner mounting surfaces where a quicker less robust install is needed.
SOCKET-HEAD CAP SCREWS (3/8” BOLT DIAMETER) - STRUCTURAL
GT2 Plastic Bezel Installation Drawing
STEP 1: SELECT MOUNTING HARDWARE
STEP 2: INSTALL
For installations that can be drilled and tapped and do not have access to the back side of
the mounting surface.
EXAMPLE OPTION 1 (LESS HARSH ENVIRONMENTS):
Vendor: McMaster Carr (www.mcmaster.com), Part Number: 96006A922
Description: Black Oxide 18-8 Stainless Steel Socket Head Cap Screw 3/8”
EXAMPLE OPTION 2 (MORE HARSH ENVIRONMENTS):
Vendor: McMaster Carr (www.mcmaster.com), Part Number: 92185A677
Description: Type 316 Stainless Steel Socket Head Cap Screw 3/8”
HEX-HEAD CAP SCREWS (3/8” BOLT DIAMETER) - STRUCTURAL
For installations having access to the back side of the mounting surface for securing a nut.
EXAMPLE OPTION 1 (LESS HARSH ENVIRONMENTS):
Vendor: McMaster Carr (www.mcmaster.com), Part Number: 92198A628
Description: 18-8 Stainless Steel Hex Head Cap Screw 3/8”
EXAMPLE OPTION 2 (MORE HARSH ENVIRONMENTS):
Vendor: McMaster Carr (www.mcmaster.com), Part Number: 93190A367
Description: Type 316 Stainless Steel Hex Head Cap Screw 3/8”
SELF-DRILLING SHEET-METAL SCREWS (1/4” DIAMETER) - NON-STRUCTURAL
1. Drill two mounting holes 7.25” apart for 3/8” bolts. Thread the holes if needed.
2. Clean the mounting surface of drill shavings.
3. Hand press the GT2 into the plastic bezel until it snaps in place and secure the assembly
onto the mounting surface with the selected hardware.
IMPORTANT NOTES
• It is highly recommended to use mounting fasteners made of a material that resists galvanic
corrosion and environmental weathering such as stainless steel. This is especially important for
marine applications where a high grade should be used.
• When using stainless steel mounting hardware, it is highly recommended to use a marine grade
anti-seize material on the bolt threads as galling and seizing of stainless nuts and stainless bolts
may occur.
• Ensure all mounting hardware is compatible with the asset.
• Ensure all regulatory and asset owner policies and procedures are adhered to during installation.
Vendor: McMaster Carr (www.mcmaster.com), Part Number: 90822A630
Description: Stainless Steel Drilling Screw for Metal, High-Strength, 1/4”