User's Guide

5 6
DOC CONTROL: HW-IS-0-0093 DOC REVISION: 200206a
DRAFT DRAFT
GT2 Metal Bezel Mounting Guide
For installations with thinner mounting surfaces where a quicker less robust install is needed.
SOCKET-HEAD CAP SCREWS (3/8” BOLT DIAMETER) - STRUCTURAL
GT2 Metal Bezel Installation Drawing
STEP 1: SELECT MOUNTING HARDWARE
STEP 2: INSTALL
For installations that can be drilled and tapped and do not have access to the back side of
the mounting surface.
EXAMPLE OPTION 1 (LESS HARSH ENVIRONMENTS):
Vendor: McMaster Carr (www.mcmaster.com), Part Number: 96006A922
Description: Black Oxide 18-8 Stainless Steel Socket Head Cap Screw 3/8”
EXAMPLE OPTION 2 (MORE HARSH ENVIRONMENTS):
Vendor: McMaster Carr (www.mcmaster.com), Part Number: 92185A677
Description: Type 316 Stainless Steel Socket Head Cap Screw 3/8”
HEX-HEAD CAP SCREWS (3/8” BOLT DIAMETER) - STRUCTURAL
For installations having access to the back side of the mounting surface for securing a nut.
EXAMPLE OPTION 1 (LESS HARSH ENVIRONMENTS):
Vendor: McMaster Carr (www.mcmaster.com), Part Number: 92198A628
Description: 18-8 Stainless Steel Hex Head Cap Screw 3/8”
EXAMPLE OPTION 2 (MORE HARSH ENVIRONMENTS):
Vendor: McMaster Carr (www.mcmaster.com), Part Number: 93190A367
Description: Type 316 Stainless Steel Hex Head Cap Screw 3/8”
SELF-DRILLING SHEET-METAL SCREWS (1/4” DIAMETER) - NON-STRUCTURAL
For securing the metal mounting bezel when bolts or screws cannot be used.
METAL BANDING - NON-STRUCTURAL
1. Drill two mounting holes 7.25” apart for 3/8” bolts. Thread the holes if needed.
2. Clean the mounting surface of drill shavings.
3. Hand press the GT2 into the metal bezel and secure the assembly onto the
mounting surface with the selected hardware.
IMPORTANT NOTES
• It is highly recommended to use mounting fasteners made of a material that resists galvanic
corrosion and environmental weathering such as stainless steel. This is especially important for
marine applications where a high grade should be used.
• To avoid staining and discoloration, zinc coated mounting hardware should not be used.
• When using stainless steel mounting hardware, it is highly recommended to use a marine grade
anti-seize material on the bolt threads as galling and seizing of stainless nuts and stainless bolts
may occur.
• Ensure all mounting hardware is compatible with the asset.
• Ensure all regulatory and asset owner policies and procedures are adhered to during installation.
Tip: This is also good for providing a security seal around the installed GT2 bezel mounting bolts.
Vendor: McMaster Carr (www.mcmaster.com)
Banding Part Number: 5422K42
Description: Low-Profile Hose Banding Type 201 Stainless Steel, 1/4” Wide, 0.020” Thick
Buckle Part Number: 5422K43
Description: Type 201 Stainless Steel Ear Style Buckle for 3/8” Wide Low-Profile Hose Banding
Tooling Part Number: 5424K3
Vendor: McMaster Carr (www.mcmaster.com), Part Number: 90822A630
Description: Stainless Steel Drilling Screw for Metal, High-Strength, 1/4”