User Guide

5 6
DOC CONTROL: HW-IS-0-0094 DOC REVISION: 200501a
RF Regulatory Notices RF Regulatory Notices
RF TECHNICAL DECLARATIONS
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment. The manufacturer is not responsible for any radio or television
interference caused by un-authorized modifications to this equipment. Such modifications could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not in-stalled and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.
NOTE: This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
REGULATORY NOTICES
Meets FCC Part 15 and 25 regulations, Canada type approval, CISPR Publication 22, and Radio Eqmt. Directive
2014/53/EU
REGULATORY NOTICES
UNITED STATES FCC PART 15/25
GT2c PRODUCTS
RADIO CONFIG MODEL: OWAC00
HOST FCCID: OWA00GT2X
HOST ICID: 10540A-00GT2X
CONTAINS FCCID(s):
2ANPO00NRF9160
2ABPY-5B9198
CONTAINS ICID(s):
24529-NRF9160
11685A-5B9198
GT2s PRODUCTS
RADIO CONFIG MODEL: OWAS86
HOST FCCID: OWA00GT2X
HOST ICID: 10540A-00GT2X
CONTAINS FCCID(s):
Q639603
CONTAINS ICID(s):
4629A-9603
GT2h PRODUCTS
RADIO CONFIG MODEL: OWAH86
HOST FCCID: OWA00GT2X
HOST ICID: 10540A-00GT2X
CONTAINS FCCID(s):
2ANPO00NRF9160
Q639603
2ABPY-5B9198
CONTAINS ICID(s):
24529-NRF9160
4629A-9603
11685A-5B9198
ID DECLARATIONS
• Satellite Transmitter Maximum EIRP and Operating Frequency
1.479 W (31.7 dBm), 1616MHz to 1626.5 MHz
• Bluetooth LE Transmitter Maximum EIRP and Operating Frequency
0.794 mW (-1.0 dBm), 2402 - 2480 MHz
• GPS Receiver Frequencies Utilized
1575.42 MHz, 1227.60 MHz
FCC RF RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End
users must follow the specific operating instructions for satisfying RF exposure compliance. The antenna(s) used
for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must
not be co-located or operating in conjunction with any other antenna or transmitter.
CANADA ISED
BRAZIL ANATEL (FUTURE)
Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência
prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas operando em caráter
primário.
O produto é alimentado por bateria interna.
Sistemas operando na faixa de 2400 MHz a 2483,5 MHz, só poderão operar com potência e.i.r.p. superior
a 400 mW, emlocalidades com população inferior a 500.000 habitantes.
Caso o equipamento utilize antenas de transmissão com ganho direcional superior a 6 dBi, devem ter a
potência de picomáxima na saída do transmissor reduzida para valores abaixo daqueles especificados nos incisos
VI, VII e VIII do art. 40 eno inciso II do art. 41 (da Resolução no 506), pela quantidade em dB que o ganho direcional
da antena exceder a 6 dBi.
Sistemas operando na faixa de 2400-2483,5 MHz e utilizados exclusivamente em aplicações ponto-a-
ponto do serviço fixopodem fazer uso de antenas de transmissão com ganho direcional superior a 6 dBi, desde
que potência de pico máxima nasaída do transmissor seja reduzida de 1 dB para cada 3 dB que o ganho direcional
da antena exceder a 6 dBi.
A descrição sobre as semelhanças e diferenças entre os produtos encontra-se no campo 16 do RACT.
ANATEL HOMOLOGATION NO: NNNN-NN-NNNN
La operación de este equipo está sujeta a las siguientes dos condiciones: (1) es posible que este equipo o
dispositivo no cause interferencia perjudicial y (2) este equipo o dispositivo debe aceptar cualquier interferencia,
incluyendo la que pueda causar su operación no deseada.
MEXICO IFETEL/NOM (FUTURE)
IFETEL HOMOLOGATION NO:
NOM-121 CERTIFICATE NO:
RCSGEGTNN-NNNN
NNNN01C0NNNN
FCC ID: OWA00GT2X
IC ID: 10540A-00GT2X
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference
to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power
(EIRP) is not more than that necessary for successful communication.
Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut fonctionner avec une
antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le
but de réduire les risques de brouillage radioélectrique à l’intention des autres utilisateurs, il faut choisir le type
d’antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité
nécessaire à l’établissement d’une communication satisfaisante.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.