SAFETY DATA SHEET GC27600 Section 1. Identification Product name : ULTIMA® Roof Sealant Crystal Clear : GC27600 Product code Other means of : Not available. identification Product type : Liquid. Relevant identified uses of the substance or mixture and uses advised against Not applicable. Manufacturer : Geocel Products Group A Business Unit of The Sherwin-Williams Company 101 W. Prospect Avenue Cleveland, Ohio 44115 National contact : Sherwin-Williams Canada Inc.
Section 2. Hazards identification Hazard statements : Flammable liquid and vapor. Causes serious eye irritation. Causes skin irritation. Suspected of causing cancer. May be fatal if swallowed and enters airways. May cause respiratory irritation. May cause damage to organs through prolonged or repeated exposure. Precautionary statements General Prevention Response Storage Disposal Supplemental label elements Hazards not otherwise classified : Read label before use. Keep out of reach of children.
Section 4. First aid measures Description of necessary first aid measures Eye contact : Immediately flush eyes with plenty of water, occasionally lifting the upper and lower eyelids. Check for and remove any contact lenses. Continue to rinse for at least 10 minutes. Get medical attention. : Remove victim to fresh air and keep at rest in a position comfortable for breathing. If it is suspected that fumes are still present, the rescuer should wear an appropriate mask or self-contained breathing apparatus.
Section 5. Fire-fighting measures Extinguishing media Suitable extinguishing media : Use dry chemical, CO₂, water spray (fog) or foam. Unsuitable extinguishing media : Do not use water jet. Specific hazards arising from the chemical Hazardous thermal decomposition products Special protective actions for fire-fighters Special protective equipment for fire-fighters : Flammable liquid and vapor. Runoff to sewer may create fire or explosion hazard.
Section 7. Handling and storage Precautions for safe handling Protective measures : Put on appropriate personal protective equipment (see Section 8). Avoid exposure obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not get in eyes or on skin or clothing. Do not breathe vapor or mist. Do not swallow. Use only with adequate ventilation. Wear appropriate respirator when ventilation is inadequate.
Section 8. Exposure controls/personal protection TWA: 25 ppm 10 hours. TWA: 125 mg/m³ 10 hours. ACGIH TLV (United States, 3/2016). TWA: 100 ppm 8 hours. TWA: 434 mg/m³ 8 hours. STEL: 150 ppm 15 minutes. STEL: 651 mg/m³ 15 minutes. OSHA PEL (United States, 6/2016). TWA: 100 ppm 8 hours. TWA: 435 mg/m³ 8 hours. Xylene Occupational exposure limits (Canada) Ingredient name Exposure limits 1,2,4-Trimethylbenzene CA Alberta Provincial (Canada, 4/2009). 8 hrs OEL: 123 mg/m³ 8 hours. 8 hrs OEL: 25 ppm 8 hours.
Section 8. Exposure controls/personal protection 8 hrs OEL: 123 mg/m³ 8 hours. 8 hrs OEL: 25 ppm 8 hours. CA British Columbia Provincial (Canada, 7/2016). TWA: 25 ppm 8 hours. CA Québec Provincial (Canada, 1/2014). TWAEV: 25 ppm 8 hours. TWAEV: 123 mg/m³ 8 hours. CA Ontario Provincial (Canada, 7/2015). TWA: 25 ppm 8 hours. CA Saskatchewan Provincial (Canada, 7/2013). STEL: 30 ppm 15 minutes. TWA: 25 ppm 8 hours. Xylene CA Alberta Provincial (Canada, 4/2009). 8 hrs OEL: 100 ppm 8 hours.
Section 8. Exposure controls/personal protection Individual protection measures Hygiene measures Eye/face protection : Wash hands, forearms and face thoroughly after handling chemical products, before eating, smoking and using the lavatory and at the end of the working period. Appropriate techniques should be used to remove potentially contaminated clothing. Wash contaminated clothing before reusing. Ensure that eyewash stations and safety showers are close to the workstation location.
Section 9. Physical and chemical properties Molecular weight Aerosol product Heat of combustion : Not applicable. : 19.239 kJ/g Section 10. Stability and reactivity Reactivity : No specific test data related to reactivity available for this product or its ingredients. Chemical stability : The product is stable. Possibility of hazardous reactions : Under normal conditions of storage and use, hazardous reactions will not occur.
Section 11. Toxicological information Skin - Moderate irritant Rabbit milligrams 100 Percent - - Sensitization Not available. Mutagenicity Not available. Carcinogenicity Not available. Classification Product/ingredient name OSHA IARC NTP Cumene Xylene - 2B 3 Reasonably anticipated to be a human carcinogen. - Reproductive toxicity Not available. Teratogenicity Not available.
Information on the likely routes of exposure : Not available. Potential acute health effects Eye contact : Causes serious eye irritation. Inhalation : May cause respiratory irritation. Skin contact : Causes skin irritation. Ingestion : May be fatal if swallowed and enters airways.
Section 12.
Section 13. Disposal considerations with soil, waterways, drains and sewers. Section 14. Transport information DOT Classification TDG Classification Mexico Classification IATA IMDG UN number UN1263 UN1263 UN1263 UN1263 UN1263 UN proper shipping name PAINT PAINT PAINT PAINT PAINT Transport hazard class(es) 3 3 3 3 3 Packing group III III III III III Environmental hazards No. No. No. No. No.
Section 15. Regulatory information SARA 313 SARA 313 (40 CFR 372.45) supplier notification can be found on the Environmental Data Sheet. California Prop. 65 WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Section 16. Other information Hazardous Material Information System (U.S.A.) * Health 3 Flammability 2 Physical hazards 0 The customer is responsible for determining the PPE code for this material.
Section 16. Other information to change and may differ between various locations and jurisdictions. The customer/buyer/user is responsible to ensure that his activities comply with all country, federal, state, provincial or local laws. The conditions for use of the product are not under the control of the manufacturer; the customer/buyer/user is responsible to determine the conditions necessary for the safe use of this product.
