User manual

Solo II CT: Consumpon 9
Calibraon
The calibraon factor is an advanced
seng that adjusts the accuracy with which
consumpon is measured. The default is 1.00.
If you think the accuracy could be improved
do the following:
1. Take a meter reading including decimal
places from your electricity meter at a
me when there is not much load. Then
go to your display, press to select [THIS
WEEK] and the centre buon to select
kWh. Note down the lower numbers:
e.g. meter reading 00324.50; Solo ll
reading 1.500kWh
2. (Please note, all gures to two decimal
places) Connue to use your household
appliances as normal for at least 24
hours. The longer you wait before
making a comparison the beer the
results. Try not to go past the end of the
week (Sunday according to the display)
as this might throw the calculaons o.
3. Take another reading from your
electricity meter when there is not much
load. Also note down the [THIS WEEK]
reading on your Solo II: e.g. meter
reading: 00342.50; Solo II: 20.150kWh.
4. Work out the dierence between
your electricity meter readings
to get your meter consumpon:
e.g. 342.50 – 324.50 = 18.0
5. Work out the dierence between
your Solo II [THIS WEEK] readings
to get your Solo II consumpon:
e.g. 20.150 – 1.500 = 18.600
6. Compare the two readings and work
out the calibraon or correcon factor
as follows: meter consumpon / Solo II
consumpon = calibraon factor. Using
this example: meter consumpon (18.0)
/ Solo II consumpon (18.6) = 0.97
7. Round up the calibraon factor to two
decimal places as above and enter this in
the [CALIBRATION] in the [ADVANCED]
sengs menu.
More details can be found at
www.greenenergyopons.co.uk/solo2
Sleep mode
The sleep mode allows you to tell the display
to turn the backlight o overnight. This is
done by entering the [DISPLAY OFF] me
and the [DISPLAY ON] me. During this me
the backlight of the display will be turned
o – if you want to see the display whilst it
is asleep simply press any buon and it will
wake up for 60 seconds.
If you don’t want to use the sleep mode
then you can set it to OFF. Using the and
buons set the [DISPLAY OFF] me to OFF
then press the centre buon to conrm.
If you set a [DISPLAY OFF] me, you will then
need to set the [DISPLAY ON] me again
using the and buons and then press the
centre buon to conrm.
Week start
Set your preferred day for the start of the
week. This is used by the display when
showing the energy usage for the [LAST
WEEK] and [THIS WEEK].
Using the and buons select your
preferred day and press the centre buon
to conrm.