User manual

Solo II CT: Consumpon8
Temperature set-point
The display can tell you if your home
is running warmer or cooler than your
ideal temperature. Use the and buons
to set your ideal temperature and press the
centre buon to conrm.
Advanced conguraon
Press and hold the centre buon for
three seconds to enter the conguraon
mode. Using the and buons select
[ADVANCED] and then press the centre
buon to conrm.
Next you need to tell the display about
your electricity meter and the rate at which
your electricity ows. You can read more
about this under the Electricity meter
secon below.
You will be asked to set the following:
• [CONSUMPTION] or [MICRO-GEN]
• [CURRENCY]
• [TEMPERATURE UNITS]
• [CALIBRATION]
• [DISPLAY OFF]
• [DISPLAY ON]
• [WEEK START]
Mode and preferences
You can use the display to monitor your
energy use [CONSUMPTION] or generated
energy [MICRO-GEN]. The default is
[CONSUMPTION] mode.
Using the and buons select
[CONSUMPTION] and press the centre
buon to conrm.
Currency
Using the and buons select your currency
and press the centre buon to conrm.
Temperature units
Select whether you want the temperature
to be shown in cengrade (°C) or
Fahrenheit (°F).
Using the and buons select °C or °F
and press the centre buon to conrm.