User manual

Solo II CT: Consumpon 5
Solo II CT: Consumpon
Seng up
Please note: by choosing [CONSUMPTION]
mode, you will not be collecng data for
[MICRO-GEN] mode. If you choose to
switch modes you will lose all data you
have collected as the display will reset to
day one.
1. Plug the power supply into
the display. Your display will turn on
automacally when you plug it into
the mains supply.
Whenever the display is turned on, you
will see the [SET CLOCK] screen.
Use the and buons on the front of
the display to adjust the me and date –
then press the centre buon when you
have nished.
2. Open the transmier and remove the
baery tab.
For a single phase pack (one mains sensor):
3. At your electricity meter, clip the
sensor around the mains live cable.
Your mains live cable is usually
idened by the colour brown, red
or the leer “L”. You should hear a
‘click’ to indicate the sensor has been
ghtly closed.
4. Insert the other end of the sensor cable
in to any of the sockets in the boom
of the transmier and ensure it is
fully inserted.
For a three phase pack (three mains sensors):
5. At your electricity meter, clip the
sensors around the mains live cables
(aach one sensor per cable). Locate
your mains live cables, these are
usually idened by the colour brown,
red or the leer “L”. You should hear
a ‘click’ to indicate that the sensors
have been securely fastened.
6. Insert the other end of the cables
in to the sockets in the boom of
the transmier and ensure they are
fully inserted.
baery tab
4
3
6
5