User manual

Solo II CT: Consumpon22
Q. The cloud icon is not showing on my
display
A. The cloud icon (top le of the display) is
only used when the oponal Web Pack
has been connected to the system.
If your bridge is not paired to the
display or it is out of range, the cloud
icon will not be shown.
To check the status of the connecon
to the bridge, press and at the
same me for a few seconds to enter
pairing mode. The display will show
[PAIRING MODE] for a second and
then show [MAIN SENSOR].
Press twice to show [BRIDGE]. If
the unit is paired it will show [CONN]
and the signal strength will be shown
using the signal strength icon at the
top le of the display. If the signal bars
are ashing, then the bridge is out of
range: move the display closer to the
bridge unl you get a signal.
If the display shows [NONE] then you
need to pair your bridge to the display.
See page 17 for pairing instrucons.
If you are sll not seeing the cloud
icon, following the reset procedure on
page 21 to reset the display.
For further technical support please visit
www.greenenergyopons.co.uk/solo2