User manual

Solo II CT: Consumpon 17
pairing buon
Bridge
(available separately as a Web Pack)
The Solo II can connect to the web using
the oponal Web Pack (which includes a
bridge). To enter pairing mode press and
at the same me for a few seconds.
The display will show [BRIDGE CONN] if it is
already paired with the bridge (bridge must
be powered on).
If the bridge needs pairing the display will
show [BRIDGE NONE].
1. Unplug the bridge from the mains
2. Hold down the and buons on
the display together unl you see
[PAIRMODE]
3. Use the buon to toggle to [BRIDGE]
4. If the display shows [CONN], hold down
the middle buon unl the display
shows [NONE]
5. Hold down the pairing buon on the
back of the bridge and at the same
me power on the bridge and keep
holding the buon unl the amber
light turns solid
The display should now read [CONN]
followed by a cloud symbol on the top le
hand corner.
Temperature sensor 1
(available separately)
For when you want two addional
temperature sensors.
The display will show [T1 SENSOR],
and will show [NONE] if it is using its
integrated sensor.
1. To pair an addional sensor, ensure
the display is showing [NONE] and
then press and hold the buon on the
addional temperature sensor unl its
LED ashes. The display will pair and
change to [CONN]
To unpair the addional sensor and use
the integrated sensor instead, press and
hold the centre buon unl the display
shows [NONE].
Temperature Sensor 2
(available separately)
The display will show [T2 SENSOR], and
will show [CONN] if a sensor is paired.
1. To unpair the addional sensor press
and hold the centre buon unl the
display shows [NONE]
To pair an addional sensor, ensure the
display is showing [NONE] and then press
and hold the buon on the addional
temperature sensor unl its LED ashes.
The display will pair and change to [CONN].