User manual

Solo II CT: Consumpon16
pairing buon
baery tab
Temperature sensors
The Solo II uses an integrated temperature
sensor. By default, this is represented as
temperature sensor 1 on the display. If you
choose to pair an addional temperature
sensor you should pair this to temperature
sensor 2 (currently empty). If you wish to
use two addional temperature sensors,
you’ll need to overwrite temperature
sensor 1. To enter pairing mode press
and at the same me for a few seconds.
Step 1
Squeeze the two clips on each side and
slide the cover o.
Step 2
Remove the baery tab from the
temperature sensor.
Step 3
Press the pairing buon on the
temperature sensor.
Pairing
The transmier, display and bridge
are supplied pre-paired. If you need to
re-pair them or add new components to
your system this secon tells you how to
do so.
To enter pairing mode press and at the
same me for a few seconds.
Transmier [MAIN SENSOR]
If the transmier (main sensor) is already
paired it will show [CONN] (connected). If
not, it will show [NONE].
To unpair the transmier press and
hold the centre buon unl the display
shows [NONE].
To pair the transmier press and hold the
buon on the transmier unl the LED
ashes. The display is now paired and will
show [CONN].