User manual

Solo II CT: Consumpon10
The oponal Web Pack pack comes with a
bridge. The bridge connects wirelessly to
your display and to the internet via your
broadband router.
This lets you connect your Solo II to the
internet and access our online energy
service, energynote. Here you’ll nd live
informaon, data storage and in depth
analysis. You can also monitor your home
and control appliances remotely via your
online account or your mobile phone.
Seng up
1. Select the correct set of pins. Insert
and twist clockwise to clip the pins
to the power supply. Plug the power
supply into a mains socket and insert
the other end into the internet bridge.
Internet bridge
Cloud not lit
If it isn’t lit either your display is out
of range of the bridge or it’s not paired
correctly. Press and at the same me
for a few seconds to enter pairing mode:
the display will show [PAIRING MODE]
for a second then show [MAIN SENSOR].
Press three mes to get to [BRIDGE]. If
the unit is paired it will show [CONN] and
the signal strength will be shown by the
signal strength icon at the top le of the
display. If the unit is not connected go to
the Pairing secon (page 17) to see how to
pair the bridge.
Cloud lit but ashing
If the cloud icon is ashing it’s because
your display is paired to the bridge but the
bridge is not connected to the internet.
Check that your router is switched on and
that you have an internet connecon.
2. Using the Ethernet cable provided,
connect the internet bridge to your
broadband router.
3. You’ll be able to tell if the display is
paired correctly as the cloud icon will
be lit (top le of the display ).
4. Go to www.energynote.co.uk to log
in or, if it is your rst visit, to set up
an account. The website will take you
through this process step by step.