Operation Manual

18
SmartPlugs 1 to 6:
After the transmitter up to 6 SmartPlugs can be paired. With the right button you can scroll to each SmartPlug
positions on the screen from left to right, and accordingly, the radio icon for this SmartPlug is displayed.

If a SmartPlug has been linked already to a position, the wireless icon is continuously lighting, even when
no connection to the device currently exists.
If the position is still available, the radio icon then flashes and „PAIR ?“ is displayed.
To pair a SmartPlug the following steps must be conducted:
1. Select a SmartPlug Number in „PAIRMODE“.
If a SmartPlug was linked already, the existing connection can be released by pressing and holding the middle
button „O“ for min. 3 s.
2. Plug the SmartPlug into a socket. Press and hold the ON / OFF button for min. 10 s until the LED turns amber.
Pairing should be conducted in close proximity to the display.
3. You should see now „PAIRED“ on the Display. The connection is completed now.

In case of problems please read the instructions at the end of this chapter.
WEB-Pack:
The display comes with the support of an optional WEB-Pack.
If this product is available on Conrad you can verify this through the product's website and list of
accessories for this product at www.conrad.com. Functionality and other descriptions must be obtained
from the WEB-Pack.
Connect additional Displays:
It is possible to mirror the screen of the current Display to other displays. However, the first Display remains with the
connection to the transmitter always the "master key" to the system.
A failure of this display means that the other displays will not work either. In principle, each display can be used as
second or third configured display (see chapter „Reset“).
Whether additional displays are available, you can see on the accessories page for the product on www.conrad.com.
For more details, refer to the separate display.

Notes for connection issues:
If no „PAIRED“ appears after a few seconds, first bring the display closer to the transmitter.
If there is still no connection, both devices should be moved to another room because of a strong
interference signal that might be present.
Please reset the Display (see chapter „Reset“).
If you still cannot connect, please contact the customer service (see chapter 1). Maybe a hardware failure
occurred.