Installation Guide

GenStone Stacked Stone products are designed to deliver an authentic stone appearance without the mortar and

mess. Although installation of GenStone is much easier than traditional masonry applications, proper installation

requires good planning and preparation. Each application varies, therefore we recommend you read this entire guide

before beginning your project. When calculating the amount of GenStone needed for your project, remember that

you will need additional pieces for unique cuts. A minimum of a 5% additional product is recommended for timely

completion of your job. Keep in mind, your leftover product can be used in other areas of your project too. It is also

recommended that additional panels be purchased and scrap pieces be kept in case a repair is needed. Observe and

obey all safety rules and recommendations set forth by tool manufacturers and Local, State, and Federal authorities.

RECOMMENDED TOOLS

• Hand Saw

• Utility Knife

• Tape Measure

• Caulking Gun for a 10 oz Tube

• 2” Non-Corrosive Deck Screws

• Screw Driver Bits

• Drill

• Framing Square

• Level

• Sandpaper

• Marker

• Gloves

• Safety Goggles/Glasses

PILLAR PANELS AND CAPS

Exterior Installations

• Table Saw

• Compound Miter Saw

• Jig Saw

• Power Sander

• Rubber Mallet

OPTIONAL TOOLS

Interior Installations

Page 1 of 3

PAGE 1
PILLAR PANELS AND CAPS GenStone Stacked Stone products are designed to deliver an authentic stone appearance without the mortar and mess. Although installation of GenStone is much easier than traditional masonry applications, proper installation requires good planning and preparation. Each application varies, therefore we recommend you read this entire guide before beginning your project.
PAGE 2
Flat Pillar Cap Peaked Pillar Cap Post Size is Key for a Successful Project GenStone Pillar Panels will apply over any structural wood post up to 8”x 8”(actual size). Please measure the diameter of your posts. A treated 4” x 4” post actually measures 3½” x 3½”, a 6’ x 6’ is actually 5½”x 5½”, and an 8” x 8” is actually 7¼”x7¼”. The idea is to build a box over your post measuring 8”x 8” (outside box measurements) by the height you want to make the stacked stone pillar.
PAGE 3
Create an 8” x 8” x 48” Box Over a 7¼”x 7¼” Post Rip four 7¼” x 48” pieces of 3/8” treated plywood. Attach each piece directly onto each side of the post to create the 8x8 box. Attach the GenStone Pillar Panels and caps according to the previous instructions for a smaller structural post. GenStone Pillar Cap - Deck Newell Post Application: The 14” x 14” cap is glued down to the top of the box framing using PL300 or equivalent.