Use and Care Manual

Use and Care
Stone and Brick
EMAIL
[e-mail]
CALL
1-855-397-1294
ONLINE
www.genstone.com
While GenStone is virtually maintenance free,
following this guide will keep your GenStone
looking as new as the day it was installed.
Recommended Maintenance
GenStone Products are some of the most durable building products materials available today. In most
cases, normal rainfall is sufcient to keep it clean. If your GenStone Products should need cleaning, we
recommend the following procedures. Particular attention should be given to areas under eaves, porches,
awnings and other overhangs that have limited exposure to the natural washing effect of rainfall.
Moderate Atmospheric Dirt
We recommend an occasional washing with clear water using a garden hose and soft-bristled brush (a long-
handled, car-washing brush is ideal for this purpose).
Heavy Industrial Atmospheric Dirt
Wash in the manner indicated above, but use the following solution:
• 1/3 cup detergent (Tide®, for example) • 2/3 cup Soilmax or Dirtex • 1 gallon of water
Caulking Compounds, Tar, Similar Substances
Use mineral spirits in reasonable amounts and apply directly to the foreign substance. Immediately after
cleaning, rinse the area thoroughly with water.
Keep It Looking New
Similar to the other siding on your home, your GenStone may present areas that require touch up paint.
We advise examining your GenStone once per year and applying paint to areas where you notice any
unpainted raw material. Paint kits are available through our website (genstone.com). For larger products,
contact our warranty team ([e-mail]) for paint codes. We also recommend applying a water
based concrete sealant every 5 years or at the rst sign of fading. Applying the sealant as outlined below
will maintain or restore the original colors and contrast.
Water Based Concrete Sealant
Typically covers 80-300 SQFT per gallon depending on surface porosity. For best results apply with a low
pressure garden sprayer or airless paint sprayer. Coat the surface liberally beginning at the top and allow
the sealant to run down the surface about 8 inches. For best sealing results, back roll the wet coat to
uniformly force the sealer into the surface.
Caution
Do not exceed the recommended concentrations of cleaners. Doing so can cause damage to the Product.
Avoid skin and eye contact with the solution, and in all cases follow manufacturer’s instructions for the use
of cleaning compounds and solutions. Avoid use of abrasive-type cleaners and strong solvents. Test any
cleaner on an inconspicuous area before applying to major areas. To minimize streaking, always follow with
a rinsing of clear water. Excessive scrubbing is unnecessary and can be harmful to the Products, and may
cause undesirable look in areas over the nish.